ULE problems

[Dawghause]

I have a new RT-ULE custom with the ULE trigger pull kit. The maker seems to work fine when I fire slowly but when I fire at any rate of speed, the trigger stays in the back position. The only way that I can get it to work again is take the air off the marker and put it back on. Any ideas? I am new to this marker. I am very careful about not short stroking the marker. I learned from my autococker about that. Any advice would be appreciated.

Thank you

Dawg

[Flow_Tech]

eaither your on/off is not screwed in far enough,you need to oil the gun,or your tank output PSI is too low,and make sure that your tank isnt under 1000PSI full.

[silentdeath55]

You probably need to adjust your ULT trigger pull kit. I think you need to add some shims, but I'm not 100% sure (like 95% though). You'll just have to mess with the ULT.

[logicmag19]

Lube up your ULE kit. It used to happen to me too.