sear fo ReTro

[pimped mag 01]

i just put a ReTro valve in my Classic mag and was just wondering if i need to get any thing special like a sear or anything thanks for any info

[Dayspring]

Nope. It should work just fine.

[pimped mag 01]

thanks for clearing that up Dayspring i was a little worried there

[Dayspring]

Where'd you get the valve from? You may have to change the on/off pin possibly.

[pimped mag 01]

i got it off of here from RGT its not of of a r/t pro or r/t, it came in a neat little box

[pimped mag 01]

why does AGD's store have 2 different sear assemblies?!?!

[afultz075]

why does AGD's store have 2 different sear assemblies?!?!

Because one is for classic rails where the sear/sear pin just drop in, and the other is for RT Rails where the sear pin is threaded into the rail. It just depends what type of rail you have, neither have any special advantages over the other.

[adiedanny]

Where'd you get the valve from? You may have to change the on/off pin possibly.

Dayspring why would you have to change the on off pin and what type of pin do you change it to? I have a minimag and I'm trying to install a retro valve but for some reason it just is not working properly. I ordered new o-rings and a new reg piston but until then I'm trying to tune it myself. I would appreciate it if you could direct me in the right direction

[Dayspring]

Because if he's pulling the valve from an RT Pro, the pin will be too long. If he's getting it from an Emag, it'll be too short.

If it's a "from the box ReTro valve," he'll be fine.

[pimped mag 01]

its "from the box" ReTro didn't pull it from an rt or emag

[Green_kat]

I'm in the same boat, but I'm pretty sure my vavle is from an EMag. Although it says Retro Valve 68 Micromag on it.

Where would I go about getting the correct sear, because I'm currently having minor problems with the bolt not resetting even on the longest spring.