want some emag tinkering ideas

[desslock]

HEY EVERYBODY!!!!

Im getting a emag from DiscoSupaFly in a week and I wanted to know if u guys had some ideas on how to boost the performance/efficency of the emag.

I have had 2 classic mags and Im swapping the xvalve and ule body from my mech mag over to the emag. I know I have to switch on/off from evalve to xvalve. I also know not to mess with the rod length, but is there any board work that can be done to the emag? Or any other little tips u all might suggest? I can follow instructions pics help LOL!

[afultz075]

Well, as far as electronics go you can upgrade the software to 3.2 if it's not already there. Umm, what else, I think there's an intellifeed port on the board so you can intellifeed a warp (not sure about a revvy), and you can get an ACE system put in (which is really a waste of money IMO because a good level 10 is enough for anti-chop and you would need your rail and body milled).

You can always mess with the trigger pull and get it to your liking as well.