E-Mag Question

[AGDlover]

OK so the other week my gun was down and Joez(from AO) let me use his e-mag. it shot great other than a small lvl10 leak. but after a few games we went up to crono and i made sure it was in elect mode pulled the pin out, the board screan lit up so i go to shoot and it wouldn't shoot at all in elect after a few games of flawless working in elect mode. so after we got back in after a game i had to run mech in he said he would just need to replace the Hall effect harness. so the rest of the time i ran it in mech. i started Venting out the back for no reason but w/e. so he recently replaced the hall harness and it still wouldn't fire in elect. hes thinking its eather the seloinide or Board. what do you think AO??

[boggerman]

I had a solonoid go bad in my emag. BlackVCG helped me diagnose it, if you are handy with a multi-meter you can check it out. I will look up the specs he gave me and post them later (I am at work now).

[Tunaman]

It should be 3 ohms across the unsoldered leads... but it doesnt sound like that is your problem. Solenoids usually don't crap out suddenly like that. Make sure the battery is fully charged and report back.

[AGDlover]

i don't have the lowers yet i'm hopefully buying them soon but i'll see