Leaking out of bolt

[Automaget]

ok i got this problem that when i ever i gas up my marker its fine i dont get any leak but then when i fire the the marker it slowly gets worse and worse with every pull i take i know i fideld with the "regulater valve pin assembly" I took out some shims and changed the "c" clip to a "E" clip insted so is there any special way i have to have the shims in there or is it another problem i think its the regulater valve pin assembly but im no tecky .....................yet

[deathstalker]

What kind of valve do you have? Actually, post your full setup.

[Automaget]

my setup is:
UlE mainbody
Xvalve
LVL10
ULT
Ygrip
RTPRO rail
dead on paintball drop

[Automaget]

Bump come on this is tech form right...........yes please need help

[deathstalker]

Did you remove shims from the lvl 10 or the ULT? Have you tried a tighter carrier? Do you have the stock on/off assembly? We need to isolate the problem, but my first guess is your lvl 10 needs tuning.

[Automaget]

ok go here http://www.airgun.com/downloads/retroexploded1.pdf on that go down to page TWO and that is what i changed around with the shims i have the orings right just what do those shims do is what im asking

[Automaget]

anyone at all?

[Automaget]

question isnt this forum supost to help people i still need help. Havent i given all the info you need? please I NEED HELP... thank you