When I tried jacking the input pressure up to around 900 or 1000 psi there was a small leak coming out of the adjustment hole where the allen wrench goes in. I though this is prbly just the reg letting off some of the excess pressure. Is this normal? the leak goes away around 850 psi. The only reason I need the pressure that high is to get a halfway decent RT effect on my vert frame. This is a Center Flag 201 Reg. Thanks.
-
It came to a point in my life when it was either pay the rent or buy paintball gear. I think I made the wise choice. If anyoneone needs me I'm livin in a van down by the river.
My Feedback:
http://www.automags.org/forums/showthread.php?s=&threadid=69554 -
I have the Dynaflow Thunder and the same thing happens to me. When I get a little past 900 psi it starts leaking. I'm not sure what causes it, but I would love to find out.Dust Green X-Mag #315
ULE body w/ dual Kila V2 detents, X valve w/ LX, Y-grip w/ Dye grips, ULT, Omega rail, Stainless Steel Freak Kit.
My Feedback- http://www.automags.org/forums/showthread.php?t=165428 -
it could be that the reg is just venting the excess air to prevent buildup in the regulator. in my opinion there's nothing wrong with it, except maybe you'll get some poor effeciency (for obvious reasons). hope that helps.Comment
Comment