I just saw a note on the agd site about the ULE warp body. It said that the body needed "slight" modifications. I was just wondering if "slight" translated into "costly machining" of the rail to fit the feed tube.
-
"Never take a sleeping pill and a laxative at the same time." -GLS -
It all depends if you have the proper tools and a steady hand... I've done both of mine with a dremel and a small file, doesnt take too much since its aluminum. But then again if you're a person who'd prefer to have someone else do it professionally the modification can be done by almost any machinest... Its a simple cut that doesnt require any odd angles so the cost is usually kept down. -
its just small notching. i did my emag rail with like 3 different bits with my roatery toolEuro E-mag | TL63 | XMOD| EM01610
Euro Rt | OG | RT02382.Comment
-
kool beans
"Never take a sleeping pill and a laxative at the same time." -GLSComment
Comment