hey I was looking at pictures of the world cup I believe and there was a hole in the revies for a warp tube to go thru. How did they do it, and make so clean cut? right now I have a Rtpro warp body in chromo, the warp hose is super short, and it gets in my revies way. So I need my revy to have this mod.
-
Life is tough nobody has lived through it. -
The way to do it the neatest is to use a drill and 1 inch hole saw. Just make sure you mark it right, because you only get one try at it. I use a dremel because it allows me to make corrections as I go.2003 SuperBowl Champions!, THE New England Patriots!
He was constantly reminded of how startlingly different a place the world was when viewed from a point only three feet to the left.
My Feedback -
I've heard the easiest way to do it is to heat the plastic up with a blowdryer on a low setting, then just take your barrel and punch the hole out.Comment
-
No, you are thinking of how they melt the hopper and "dent" it to give the hose room to clear the hopper. In this mod the revy shell is still intact.2003 SuperBowl Champions!, THE New England Patriots!
He was constantly reminded of how startlingly different a place the world was when viewed from a point only three feet to the left.
My FeedbackComment
-
headcase i don't think a hopper with two holes in it counts as "intact"
that's just my opinion though. hehe.
Comment
-
Originally posted by headcase
No, you are thinking of how they melt the hopper and "dent" it to give the hose room to clear the hopper. In this mod the revy shell is still intact.
My bad grammer strikes again....in the above quote I meant that the melted hopper mod leaves the Revy intact.2003 SuperBowl Champions!, THE New England Patriots!
He was constantly reminded of how startlingly different a place the world was when viewed from a point only three feet to the left.
My FeedbackComment
Comment