revvy too loose in warp.

[E r y k]

hey agd,

i was playing today with the warp and rev, and when i slid into a bunker, the revvy just went over board. is there anything to hold in the revvy more securely?

i ran a search and i came up with some less permanent solutions such as electrical/teflon tape around the neck, but i dont want to apply tape each time i play or clean the revvy.

what can i do?

[BD_Paintball]

ive noticed that if you tighten the screws holding the warp together that are by the opening where the revy goes into the warp that the revy will sit a little tighter in there.

if you dont understand what i am saying, just tighten the screws on your warp shells if they are loose, that works for me.

[�?�� �m���]

a ring of electricity tape around the feedneck will hold and you won't have to take it off the feedneck each time cause it dosen't crumple like teflon tape does

[AGDlover]

hockey tape wooks awsome its kinda like elect tape but with a rough textured side on the outside

[riooso]

Some of the hopper inserts will expand your neck ever so slightly and then you can loosen the screws and put it in then tighten a little. Don't get your hopper to tight because instead of coming out during a crash it will break the neck of the hopper.

R

[athomas]

I had to put a ring of tape around my revy when I used it on the warp. It worked fine and wasn't any hassle.