When I was using my E-Mag on Saturday I was having some issues with my Flatline recharging quickly enough for it. So I cranked the pressure up to about 1100 psi to see if that would help. It did a little, but I noticed I got an occasional leak coming out of the hole on the side of the valve. Is this hole for bleeding off excess pressure or is something else causing the leak?
-
-
That's an over-pressure saftey. It makes sure you don't send non-regulated air into the air chamber, thus resulting in a REALLY hot shot.
Lube the reg pin, if that doesn't solve it, replace the pin. -
I noticed it stopped venting when I turned the pressure back down to about 850-900psi. I just got this back from Tuna so I imagine if the reg pin would need replaced he would have noticed it. I'll try lubing it.Comment
Comment