maybe found the problem
Hey guys I just got my Xvalve and ste it in my ULE body and got bolt stick with the field strip screw tight. After loosening it slightly all was fine. So I did some measuring and found that the Xvalve is .006 smaller than the body.
So as a result as you tighten the screw the valve pulls down at the back , up in the front. And bolt stick.
So I tested it with a shim under the valve and all the stick is gone.
Try this test on yours with a piece of paper under the back of the valve between the valve and the rail. You may have to fold the paper to get the correct thickness.
Hope that helps you, it worked for me.
Hey guys I just got my Xvalve and ste it in my ULE body and got bolt stick with the field strip screw tight. After loosening it slightly all was fine. So I did some measuring and found that the Xvalve is .006 smaller than the body.
So as a result as you tighten the screw the valve pulls down at the back , up in the front. And bolt stick.
So I tested it with a shim under the valve and all the stick is gone.
Try this test on yours with a piece of paper under the back of the valve between the valve and the rail. You may have to fold the paper to get the correct thickness.
Hope that helps you, it worked for me.
Comment