noob Q's

[FireITup14]

ive posted many noob mag questions before but heres another, where is the on/off? how do i lube the o rings on it? also ive gotten mixed answers, lube the side of the bolt or no?

[FireITup14]

k i know where the on/off is but how do i get the little bugger out

[ramenjames]

pull it out

and just put some oil in the back of the valve (2 holes with oil writen neer it) and fire a bunch

you should be good then

[athomas]

Putting oil in the "oil" holes does nothing because they provide no access to the internals of he valve. Drop a couple of drops of oil in your ASA before you put you bottle on the gun, or in a quick disconnect coupling at the valve. Dry fire the gun without the barrel until you stop shooting out oil residue. You should be good to go for the day unless you have a level 10 and shoot an extreme amount of paint. The level 10 requires a bit of oil every once in a while more than the rest of the gun needs it.

[toymyster]

The on/off assembly pulls right out, it's a bit more challenging if you have no fingernails!! Once it's out, clean the pin really well and put a light coat of good quality oil on it, put a drop of oil on your fingertip and smear it on the o-rings, put a drop of oil in the bottom of the hole, put everything back together, gas up and fire about 50 times without a barrel, and that should take care of it!!! Hope this helps!!!

[Sticknes]

"The level 10 requires a bit of oil every once in a while more than the rest of the gun needs it." - how do you oil just the level 10? and where?

[Dayspring]

A few drops of oil on the bolt piston (the tube inside the bolt itself) and slide that back and forth in the powertube.