ULE Tigger install problem

[twd4]

Help

I cannot get my ule trigger pull kit into my rt pro x valve. I got the old one out and when i try to put the new one in it goes in but wont seat into the window. By this i mean the top square end will not seat down into the cut out in the valve. The stock one goes back in with no problem. Is it possible i have a bad kit? I tried emailing airgun design but they are not accepting emails right now...whats up with that??? Anyone else having this problem?

[twd4]

problem solved.....

[tackyoneagd]

I'm haveing the same problem how did you fix's it. HELP!!

[Alpha]

Well first of all I need to point out the obvious.. ITs a rectangle. Make sure its perfectly lined up. It should be pretty snug, so use oil.

Make sure its assembled correctly, adn there aren't too many shims in it. IF you haev too many shims in, it won't fit in compeltely, and you won't be able to slide the valve into teh body because the ULT gets hung up on the body.

ITs okay if its stickign out a little bit, I think mine does. Actually mine DOES, I'm holding my valve now.

[sabrefanpc]

also some of the older rtp valves need to be drilled. check the ult thread for more info.