I recently encountered problem with my newly aquired warp. What happens is, my jumpers are all set correctly, one jumper on (sens) and 4 jumpers on the others, allowing the shortest dwell. when i mess with the sensitivity dial it'll only spin when turned up all the way. when i back out and tap or shake it. nothing happens, any ideas? could AGD fix for free? Is there a board I can purchase? anything?
-
usualy turn it until it spins full then back it off a bit and u should be fine. if it stil doesnt work check the manual again then maybe give agd a call
-
TRy it on the gun. Sometimes the sensor can be picky. Also. check out THIS ! HAVOC is the man with a warp!
The gun is 1/8" of a game that is a FOOT long!
(...but a 'mag helps)
I know I was born and I know that I'll die...the in between is mine. -Eddie Vedder
Sinister SainthoodComment
Comment