ok, i have an e-mag. electronic and hybrid work perfectly. whenever i shoot it in mechanical mode, the sear gets stuck. it pushes the on/off about halfway. i either have to press the sear again or let it reset slowly. while its resetting, air will just leak. does anybody know how to fix this?
-
oil the gun wel if u havent. check the on/off but it sounds more like a lvlX problem but im nto sure why it wouldnt do it in e-mode too then. make sure lvlX carrier isnt too tight
--edit sry u said u ahve an x-valve in it? doesnt the e-mag use a special on/off?
-
Your trigger rod is adjusted too short. Put the gun in E-Mode and gas it up, but do not turn on the gun. Then pull the trigger and look a the gap behind the trigger to the tip of the trigger rod. With your situation, there should be a considerable amount of gap. You want the trigger rod to take up as much of that space as possible, but still leave about 1/16" gap so you don't get trigger rod bounce in E-Mode.
Also, if you're using one of these aftermarket blade triggers, you can forget about getting M-Mode to work properly.Comment
-
oiled the on/off. it actually happens on e mode also. just a bit harder to notice.Comment
Comment