It has been said many times that the ult should not be used in an Emag because the return force is lessened. Since the ult is adjustable via shims to increase the return force, could you not adjust the ult to the point where it functioned similar to a stock on/off? I'm not sure that there would be much practical reason to do this unless you were adding an Emag lower to a gun that used the ult, just wondering if it works, since by adding shims you are essentially affecting the length of the on/off pin right and the emag uses a longer pin. So, is it the size of the top of the pin(lack of surface area to act on), or length of the pin that is the issue?