i need serious help

[SPECIAL_K_06]

i just bought a ule body and having some major trouble getting it onto my mag. theres a metal piece, i dont know what its called, that is holding it up. everything is lineing up in the back, but it slants up as it goes forward. what do i do?

[WenULiVeUdiE]

I think you are referring to the twistlock assembly. That's most likely your problem, and the only one I can think of.

[SPECIAL_K_06]

how do i take it out?

[JimmyBeam]

get a pair of needle nose pliars and yank it out

[SPECIAL_K_06]

from the top or the bottom? i tried just screwing it in but it stayed elevated, so that should work.

[temps]

if all else fails.. use a bigger hammer

[JimmyBeam]

if i remember right i yanked it out from the top. hope that helps

[JimmyBeam]

and yea, a bigger hammer always works

[SPECIAL_K_06]

thanks, will this hurt the gun at all?

[JimmyBeam]

no if anything you may scratch the rail, just be careful and take your time

[SteelSoul]

DUDE dont hit it with hammer

Look at the bottom of the rail for a allen head
Unscrew it and it will come out

NO HAMMER

[flyinasian016]

Flip the rail over. take a hammer, and hit the metal peice sticking out! and then, ick up the metal peice from the floor, put it back into the rail, and hit it back out again. Hammering things is fun

[punkncat]

When the rail is off , on the front bottom of the rail you will see the twistlock sticking out where it protruded into the tragger frame.

Get a nail and hammer. Turn the rail over on a flat surface leaving room for the twistlock to come out. Place the end of the nail(or punch of you have real tools) on the twistlock and knock the heck out of it a time or two with a hammer. And as flyingasian put it "pick it up off the floor"......

[Rift]

Flip the rail over. take a hammer, and hit the metal peice sticking out! and then, ick up the metal peice from the floor, put it back into the rail, and hit it back out again. Hammering things is fun

ohh my lol

[SPECIAL_K_06]

ok, now i am ticked. that metal piece still wont come out. i have tried hammering it, and it still hasnt moved. what am i doing wrong?