Problem With Valve and On/Off 56K Warning

[SpitFire1299]

Hi.. ive been having a lot of problems with my valve on/off assembly. I have a paintball war in about 5 days.. and really need help.

My Problem-

I dont know how to install my on/off assembly. I looked at my diagram, and my parts look NOTHING like my valve on/off assembly. What happens is the gun wont shoot... The pin is straight, i think i have all parts.. i just dont know how to put it in!

Ex.

I have all the orings.. and the piston, pin, and this other piece that doesnt look at all like the one in the diagram.

My gun Facts

I have a minimag with an intelliframe...

I dont Know what kind of valve it is. Im assuming its a regular valve... one that comes stock.

PICS BELOW!!

I bought this gun off ebay...

[SpitFire1299]

Its well oiled, and the pin slides through the piston well.

[nate2k191]

min looks a bit dif than urs but look at these pics, they may help

[SpitFire1299]

THANKS! Problem Fixed!!

[the electrician]

that's just an aftermarket piece. it was suppose to improve the recharge of the gun but it doesn't do anything.

if you have both of the o-rings that go in first, it should work fine.

see how the brass piece has four points on one side, put them facing down, on top of the on/off bottom. then put your two o-rings on top of the smooth brass surface, one inside the other. should work fine.

[Tunaman]

the diagram to install it is Laser etched in the side of your valve. Check it out! TK knew this would happen!