Tech question.

[Crestfallen32]

Well in asking this question, I feel like a newb. Though I have had my mag for about 2 years now. But the few weeks I have had some problems with it. First off the stats, or as close to it as I can get.

Ule Body
AM/MM rail
Intelli
Minimag valve
Level 7 bolt.

I'm not absolutely sure about the bolt, but I seem to recall the guy saying he didn't do anything but put a xchamber on it.

Anyway, the problem I am having at hand. Is it common for air to push back up the feed tube? I keep smashing paint in the hopper, in a halo (took me 2 hours to clean), a 12 volt xboard revvy, and grav feed. I just recently replaced all the orings in it. And I run it off a nitro duck high pressure 47 3000 tank.

Thanks for the help.

[eNder159]

hmmm well being that its a classic valves...those suckers were designed for power fed bodies to let air escape to prevent the ball stackage problem..but since you have a halo it shouldnt be breaking balls like that since its force feeding the balls down the stack ..hmmmm