size of foregrip screw?

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Stealthgerbil
    Registered User
    • May 2004
    • 196
    #1

    size of foregrip screw?

    I know the front foregrip screw is 10-32, but how long is it? heres the link to the screw Link
    I lost mine, and I would rather just go out to the hardware store and buy one there instead of ordering it, so I need to know the size.
    I have a ReTrO Mag
    -ReTrO Valve /w ULT -E-mag Warp Body
    -Intelliframe -Warp Feed
    -LVL10 Superbolt
    -Dye Xcel 14inch
    Tags: None
    • VR4SL
      Registered User
      • Oct 2003
      • 90
      #2
      10-32 x 3/4 in the case of the X-Mag/E-Mag.

      I have them in Stainless if you want a couple...
      Black-to-Red Fade Dust CNC X-Mag VV04947

        Comment

        • bertmcmahan
          Not pop, it's all Coke
          • Jan 2002
          • 1960
          #3
          With screws if I don't know the length I just get a couple packs, if one is too short and the other too long I will just cut down the long one. Sometimes you have to run it through a die to get it to fit right but that would save you a trip to the store.
          AIM-bertmcmahan
          My email:[email protected]
          My feedback thread
          Good traders: richie,Roguefactor,moufo48,845,brtncstm160,vf-xx

          Mags don't shoot darts... they shoot nails.
          I used to be bertmcmahan, that I did.

            Comment

            • Stealthgerbil
              Registered User
              • May 2004
              • 196
              #4
              i have an automag, but if they are 3/4 inch, then I'm sure I have some. Thanks a lot.
              I have a ReTrO Mag
              -ReTrO Valve /w ULT -E-mag Warp Body
              -Intelliframe -Warp Feed
              -LVL10 Superbolt
              -Dye Xcel 14inch

                Comment

                Previous template Next
                Working...