Help me please!!

[LunchBox89]

ok i have a ptp micro arena mag. I gased it up today with c02 the trigger got stiff so i knew the air was flowing i pulled the trigger and the bolt didnt move and it was just a pffft so i thought maybe my ball detent was to tight and infecting the spring so i took it off and tryed no good.

here is my total noob question:
i have my spring in front of my bolt and it slides over the bolt is that right



thanks

[VFX_Fenix]

Yes, the return spring rides over the bolt and infront of it.

[LunchBox89]

ok theres one question i hope i dont have to pick up a xvalve now because this valve wont work

[AGMICROMAG]

picking up an x-valve is exciting.....great things happen!

[LunchBox89]

i know i want to get a xvalve put the money tree has seemed to have run out

[athomas]

Try increasing the velocity.

[kevdupuis]

Try increasing the velocity.

I've forgotten about this fix before, play around with the mag for half an hour only to realize I didn't turn the velocity up.

Lunch box on a side note.
Do you have a field nearby, I was thinking of heading down your way and if you were interested, going through your mag with you and get some light play in.

[LunchBox89]

the nearest feild is outback and at the moment i have a mask and my mag and a vl 200 and no money until after this weekend i should have 70 (hopefully) and when i try to turn the velocity up it wont budge it feels like im going to ether break the allen key or the screw

[darrickws]

Check the sear...

Make sure when gassed up there is enough space to fit a dime between the sear rod and the back of the trigger. I have had it move forward before. If the rod is pushed had against the back of the trigger, then the on/off is not getting charged. This happens alot when you put a benchmark trigger frame on or sometimes the rod comes loose and slowly creeps forward.

If this is the problem, you need the screw the rod back a turn or two, until you can fit a dime between the trigger and rod WHEN GASSED UP.

gl!

[kevdupuis]

the nearest feild is outback and at the moment i have a mask and my mag and a vl 200 and no money until after this weekend i should have 70 (hopefully) and when i try to turn the velocity up it wont budge it feels like im going to ether break the allen key or the screw

No problem the wife and I will be in the area on Saturday. If you want we can go through the mag, set it up, find a spot and burn through some old paint I have.

[LunchBox89]

i dont think ill have a drive out this weekend moms working

[LunchBox89]

Can some one please help me i cant turn it its so hard that i think it might even be in all the way so i dont think its the pressure

[athomas]

Take the valve apart and clean it, including the back section where the regulator piston assembly is. This will verify that the adjuster and piston is moving freely as well.

[kevdupuis]

Lunchbox, why don't I come to Port Hope tomorrow with my tools and I 'll go through your mag with you. It sounds as if something is really binding in the back of the valve.
I have plenty of spare pieces, so we should be able to get it working properly.


Just have to load wife, tool box and some air tanks in the van.

[LunchBox89]

dude that would be sweet but i wont be around being 15 doesent give me much freedom i have to go out to my grand ma's shes in a nursing home in belleville thanks for the offer dude


add me to msn and we can set up a time cause i would really love to get my mag working my msn name is [email protected]

i gotta say thanks for offering to help me