LvL 10 Bolt!

[AGD202]

since e-mags come with lvl 10 bolts... i put a shop rag down in mine to see if it worked... it cut the rag like it was nothing... why wont it stop?

[eNder159]

since e-mags come with lvl 10 bolts... i put a shop rag down in mine to see if it worked... it cut the rag like it was nothing... why wont it stop?

are you sure its the lvl 10 bolt? and did you put it furthest away from the bolt? if so it wont stop it unless you have the rag touching the bolt...did u shove a big chunk of it in the feedneck? howd u put it in there?

[AGD202]

i just stuck it down the feed neck and put enough that it stopped on my RT's bolt..

[Rift]

if you just put a thin peice of the shop rag down in there it wont bounce of that theres not enough force hitting the bolt to activate it. and are you sure you have a lvl 10? if you look at the bolt dose it have a stem sticking out the back?

[AGD202]

it sure was not just a thin piece... 1st of all i had to wad it up to get it down there but my mag is out in my car right now but i do know it is the lvl 10 cuz it came w/ the pack of carriers

[jctam]

With the kit, it should also have 2 springs a red one and a really long one. Try putting in one of those.

[athomas]

If the rag could get pushed to one side of the breach, then it could still get chopped. The anti-chop only works for the first 1/2 of the stroke. If the rag gets pushed to the end of the stroke then it will get the full force that the mag can deliver (it will cut).

[darrickws]

yep, try it with a plastic pen

You have to try it with something harder than a rag, and you need to make sure it is down the feed tube on the bolt side not the barrel side. If you put the pen towards the bolt, it will hit and bounce back, If the pen is closer to the barrel, the bolt goes past the "point of no return" and will clamp down on the pen.

gl