I have a pre Brass Eagle 12v (no x-board) hooked up to intellifeed from my intelliframe. I've been meaning to ask this question for some time as I have hade it hooked up for a few months now. Anyway, I noticed that when there are no balls in front of the sensor it spins normally but then if I hold down the trigger it picks up the pace noticeably. My question is will that burn out my motor eventually? I think that it's different from the x-board revvy because the later has a regulator. Is this right?
-
AIM "Cypres0099" -
UP. Help me out with this guys. The last thing I need is to toast my revvy in the middle of a game.
AIM "Cypres0099" -
My brother has an itellifeed set up and it does the same thing.... hasnt burned up yet, but he hasnt had it for long... we shall see.-Gig 'Em Ags!Comment
-
It shouldnt because it should only turn if theres no balls in the hopper or you pull the trigger, it still operates at same voltage from battery in viewloader not another power source. If you increased the power then you may have a problem but if you run run it off normal battery setup it shouldnt hurt it all......Comment
![[NA]WARLORD](data:image/svg+xml;base64,CgkJCTxzdmcgeG1sbnM9J2h0dHA6Ly93d3cudzMub3JnLzIwMDAvc3ZnJyB2aWV3Qm94PScwIDAgNTAgNTAnPgoJCQkJPHJlY3Qgd2lkdGg9JzEwMCUnIGhlaWdodD0nMTAwJScgZmlsbD0nIzk0NjI1NCcgLz4KCQkJCTx0ZXh0IHg9JzUwJScgeT0nNTAlJyBmaWxsPSd3aGl0ZScgZm9udC13ZWlnaHQ9J2JvbGQnIGZvbnQtZmFtaWx5PSdBcmlhbCcgZm9udC1zaXplPSczMDAlJyBkb21pbmFudC1iYXNlbGluZT0nY2VudHJhbCcgdGV4dC1hbmNob3I9J21pZGRsZSc+WzwvdGV4dD4KCQkJPC9zdmc+CgkJ "[NA]WARLORD")
Comment