Can I fit a stainless steel body on a ULE rail?

[Green_kat]

The stainless steel body doesn't sit flush with the ULE rail I recently recieved.

Is is possible to mill out the ULE rail to allow the stainless steel body to sit flush?

If so, will it be possible to use a ULE rail later?

What I refer to is the circular opening in the ULE rail just behind where the tiwst lock assembly used to be. If I make it squarish to allow the stainless steel body to fit will it wobble and will it ever be possible to use a ULE body later in life?

[AGDlover]

who did you recive the rail from?

[Tunaman]

You can either make the square PIM round on the stainless body, or make the rail square to accept. Either way doesn't matter and won't hurt anything. I have done a few of them.

[Green_kat]

Thanks a lot.