Emag Lowers Help...

[Green_kat]

I have recently purchased a set of emag lowers and a micromag rt valve.

When gassed up, the sear rod will not come forward at all.

On the odd time i gas it up the gun will either fire once of its own volition and then remain uncocked. Or it will fire once in e-mode and then remain uncocked.

I have tried it with level 7 internals and it still did not work. I assume the problem lies with the on/off assembly. If this is indeed the problem will I have to replace the on/off assembly?

Thanks in advance.

[Green_kat]

Ps: I'm using a blue bumper until i can replace the clear one.

[kdawg]

Emag lowers and micromag RT valve......what body and rail combo are you using? Most likely your on/off is not the right length. Check the spec sticky about it....................

[Green_kat]

I am using an SS body and a ULE e-mag rail. Does the entire on/off have to be replaced? Or can I just buy a pin?

[Dayspring]

Just the pin. And yes, you need a new one.

If it's a 1 oring on/off (take the assembly out and look in the hole) you need a .728". If it's 2 orings, you need a .712".

[Green_kat]

I don't see the .728 pin in the store. How do i go about getting one. I appologize for all the questions.

ANd how much does it cost?

[Green_kat]

Nobody knows where to get one of these pins?

[Dayspring]

Costs the same as the other ones. You may have to call up and ask, only because the .728 pin was fazed out in deference to the .712.

[Sk8ermog]

Yeah they are harder to come by so send a PM over to Tunaman or one of the other AO techs on here and they should have a spare one or some advice. Also you don't have to apologize for asking too many questions. That's what this forum is all about. We are here to serve.

[B.A.M.]

the searing rod also doesnt come forward on my gun so wat should i do
(ive posted this same question and no one can give me a strait answer

[Dayspring]

You're going to have to give more information than just that...

Level 10?
Tank pressure?
Tank output pressure?
Aftermarket parts?