Firing mode on emag

[shredder74]

Can I have firing mode on Emag with 1.35 soft, if I can where must I installed jumper on circuit board? thank you for your answers

[Dayspring]

There's a 4 pin jumper on the board. There should be a white jumper with a brown wire looping to pins. That gives you a 3 and 6 shot butst mode. That's all the firing modes available.

[shredder74]

I took a photo of my board and I haven't got pin with brown wire can you tell me which pin I must shunting

Thanks for your answers

[Titansu]

I took a photo of my board and I haven't got pin with brown wire can you tell me which pin I must shunting

Thanks for your answers

Pin #4... I have one I don't use, PM me your addy and I'll send it out to you.

[shredder74]

Send a pm

[kdawg]

There's a 4 pin jumper on the board. There should be a white jumper with a brown wire looping to pins. That gives you a 3 and 6 shot butst mode. That's all the firing modes available.

which pins does the loop connect to?

[Dayspring]

If you're looking at the picture the guy posted, it should be pins 3 & 4 (towards the bottom of the gripframe.

[rkjunior303]

dayspring -- on the newer software, such as 3.2 what does that jumper do? is there a tourney lock?

[Dayspring]

Technically, it does nothing, but that jumper block also has the pin for the ACE on equipped guns. so while you may not need the brown wire in there, you need the block if you want your ACE eye to work.

[rkjunior303]

gotcha. thanks again.

[shredder74]

Dayspring-- send a pm

[Dayspring]

http://store.airgun.com/index.cfm?fuseaction=catalog.prodInfo&productID=285&categoryID=24

[shredder74]

Thank you for your help