hopper to warp fit problem

[guest player]

any tips on how to keep my revvy from falling off my warp while i'm playing? i'm currently using electric tape wrapped around the hopper male end to get a better fit, but it still manages to come loose if i don't keep my eye on it. thanks.

[scarpa43]

When I used a warp I bought some adhesive sand paper, cut a couple strips and put it on the inside of the feedneck of the warp.
Once it was tightened down I never had a problem.

[Dayspring]

A neck spacer. Dye makes them. They go inside the revvy neck and expand it just a bit bigger.

[xen_100]

a more permanent way is the way I did it.

put the revy in the warp and drill it straight through from one side to the other.(use the drill size for a 4-40 tap) then tap the warp for a 4-40 screw. now go to your local hardware store and get 2 plastic 4-40 flathead screws. screw them into the warp so they retain the revy. (one on each side) you will have to shave the length of the screw so it doesn't interfere with paint feeding.

I have had mine like this for 3 years. never had my revy fall off.