If I set my flatline output to 900 should it stay there?

[riooso]

If I set my flatline 3000 psi tank for an output pressure of say 900 psi should it stay there when my tank pressure goes to 2000 psi, or 1500 psi ? My output pressure changes from 700 to 1000 depending on the tank pressure. Help would be appreciated.


Thanks,
Riooso

[Rift]

well thats deff not normal that usually only happens once the tank is lower then 1000 psi or even less. Ii know when i had a similar problem with my pressure going all over the place my reg seat and spring pack were changed. Im betting its one of those two things but i also bet Tuna would knoe fore sure.

[jctam]

I have this problem too.

[BlackVCG]

Read my Flatline maintenance thread in the Gun/Air System thread stickied here in the tech forum.

If that doesn't help you guys out, I can go through your air systems and get them back in shape.

[jctam]

Since it is a 3k Flatline, I replaced the o-ring for the reg seat. I also have the flatline parts kit. I've gone through the reg half. I haven't gone into the on-off. Your guide didn't show how to do that. I think it might be dirt making it perform so badly.

[riooso]

I guess the most important thing is that I wanted to know is if this is a normal thing. I have had this flatline so long I have forgotten.

Thanks,
Riooso

[BlackVCG]

I didn't go into the on/off disassembly because it's not something your average FL owner should be doing.

It is not normal behavior for the FL to do that, just so you know.