Hall Sensor Agg...continuation of E-Mag Agg

[rgt]

Hall sensor is in. I have it bent the correct way. When I test it with the trigger, it goes ON, OFF...etc. when pulling the trigger. When I try to install it, it istouching the frame an staying ON.

Is there something to do like put a piece of electrical tape infront of the sensor?

I have the sensor bent in such a way that when installed, it shouldn't hit the frame...but something is (I think it's the bare wire part of the sensor)

[BeaverEater]

You might just want to put a little tape over the bare wires. That might solve the grounding problem.

[Fanatic]

um...where is your plastic holdee-the-hal-sensor-thingamajig on your frame?

[Tunaman]

10 bucks says your trigger magnet is too close to the HES.

[rgt]

Tuna-

Refresh me on the HES. Isn't that the hall sensor?

When you say too close, do you mean while the trigger is forward or pulled?

Thanks

[t33kyboy]

The hall sensor turns on when the magnet on your trigger gets close to it... sounds like your magnet is to close, causing it to stay on without pulling on the trigger. use a allen wrench to adjust the magnet on the trigger.