Manual Mode Won't Work

[BeerCitySk8brds]

When I try to put my E-Mag in just Manual Mode it will not shoot. I have the Fireblade installed.

The trigger can't go far enough back to shoot it. I took an allen wrench put it behind the trigger and it was able to shoot.

Any Suggestions?

[t33kyboy]

Adjust the trigger rod length.

[BeerCitySk8brds]

I was wondering if anyone else had problems w/ the fireblade. On the back of the trigger there is a hole that the trigger rod goes into. It would work with the stock trigger.

[warbeak2099]

Does the Fireblade have a screw in the middle that adjusts sear contact? I know the Logic vert frame's trigger does. If it does, try screwing that in until the trigger is close enough to the sear rod.

[athomas]

The trigger rod needs to be lengthened.

It is long enough once you can pull the sear far enough to allow the bolt to cycle consistently every time. Be careful not to get it too long. Too long and it will hit the back of the trigger and cause excessive bounce when firing in e-mode.

[BeerCitySk8brds]

Alright I will give that a Whirl. Bounce Eh. I'll have to try that too.