Intelliframe to Warp Feed

[AllAmericanMag]

How do you hook an Intelliframe to a Warp Feed to make the warp spin upon pulling of the trigger?

[PowderdToastMan]

theres about a million threads with tha same question.... do a search

[[NA]WARLORD]

Yes there is but nobody seems to be able to answer the question.......

[AllAmericanMag]

TOM!!!

[AGD]

Install the switch in the Intelliframe, run wires from the switch contacts to a phone plug. Plug that end into the Warp and set the warp jumpers to negative turn on. That means the set of three jumpers has one on the top and another on the bottom.

Thats all!

AGD

[AllAmericanMag]

Thanks Tom, you rock!

[ben_JD]

Where does it plug into the Warpfeed. I just ordered mine and haven't laid eyes on it. Is there a phone plug there also?

I already have my Intelliframe tied into my Revolution, but have dumped that for the HALO and want to merely tie the Intelliframe directly into the Warp.

Any insight?

[[NA]WARLORD]

No not a phone plug, but a hole is there to put an interlink cable for e-mag, which you can buy and strip off ends and link to your intelliframe, or buy headphone extender from radio shack and adapt that way, but since i dont have my Warp yet, i really cant say. Sorry !!

[ben_JD]

Originally posted by AGD
That means the set of three jumpers has one on the top and another on the bottom.

It seems that by having the sensor on as well as the intellifeed, one would be subject to many more false-positive feed cycles. Is there really a benefit to this?

[[NA]WARLORD]

If you already have the intleframe linked to your revvy, you shouldnt need to intelefeed your warp. It responds to the recoil ( or kick) of your bolt when it cycles, it (warp) also has a sensitivty adjustment if you dont like how fast it responds, Lastly the phone/ link jack is on back side of warp, under black back plate.

[ben_JD]

I don't use a Revolution. The hopper I do use, though, seems to keep up well enough on its own. Hence, I intellifeed the Warp.

[[NA]WARLORD]

Just going on info you put in earlier post.........

[PsychoMag]

Originally posted by [NA]WARLORD
If you already have the intleframe linked to your revvy, you shouldnt need to intelefeed your warp. It responds to the recoil ( or kick) of your bolt when it cycles, it (warp) also has a sensitivty adjustment if you dont like how fast it responds, Lastly the phone/ link jack is on back side of warp, under black back plate.

You most definitely SHOULD intellifeed your warp...I would do it over the revvie. The warp loses sensitivity as the batteries get lower. Also, if the gun isnt a mag andit has a low recoil, then u have more headaches.

[[NA]WARLORD]

Try that 2 battery set-up that other dude came up with, that should help with your battery problem, also try rechargable batteries, keep a few on the side for back up. I just hooked my warp up, the setting is on 7 and it works great. I also intellifed my inteliframe to my revvy, which made more of a difference than to my warp, but whatever works for you, more power to ya, not a flame, just an observation..........