M98E and Warp prob...

[Pstan]

I've added a Warp to a Model 98 E recently. The gun has a BSI E-Bolt and is running at the normal 800psi input. The problem is Warp sensitivity. Once I get the warp sensitive enough to spin at each shot, it sometimes (most times) spins non-stop until unplugged from the battery. Conversely, if I reduce the sensi setting the warp wont spin at all.


Ideas?......



Thanks in advance.....


PsTaN

[MonsterMag]

what kinda warp is it?

[Pstan]

AGD - like new

Never been modded or changed in any way.

[MonsterMag]

Not sure , but I think you might need a Pro-Team Products Warp , I dont know

[trains are bad]

Intellifeed is the only way. It shouldn't be hard.

[Pstan]

The Pro-Team does use an external sensor, but other than that the feed adapter is the only difference that I know of. I really like the 98/Warp Combo and I'm determined to get it to perform at it's peak. Think I'll shoot over to Model98.net and see what the boys there got to say.


Thanks...


PsTan

[Duck Hunt]

Find the micro switch in your electric grip. Piggy back off of it and intellifeed your warp. That should do it.

Sean

[Pstan]

BSI E-Bolt has the switch soldered directly to the board with no leads. To intelli I'd have to solder directly on the board...........dont know if I want to risk that.

PsTaN

[trains are bad]

Than set the warp jumper to the pins for a pulse, (middle I think) and tap into the wires going to the ram/solenoid.