OK so i just dry fired my gun and i am gettin 2 shot bursts and 3 shot bursts of bounce. I have 1.37 software my trigger pull is kinda short. Also with regular firing is the back of the mainbody were the valve and what not is suppoused to get hot? Thx
-
"Life Is A Garden Dig It" Joe Dirt
Black powerfeed Emag 1.37 w/ warp and ev2 :headbang:
lookin for emag ups u got em i want em :shooting:
98% of american teenagers have tried pot. if you are part of the 2% that hasnt, put this in your signature. :wow:
My emag shootin with crap paint and old ev2 -
I'm pretty sure its normal for RT/Emag valves to heat up.
As for the bursts, try backing out the trigger magnet a tiny tiny bit? I dunno, that may help. -
I sent my gun into BlackVCG and he said that my gun was bouncing because the wiring was mixed up somehow. Now this is with 3.2 software but I would check with him. As for the valve heating up make sure your pressure isn't too high, and I think it is supposed to heat up as well, there was something about that in the "how to" part of chronoing an RT Mag. Something about how the air expands and heats I think??Comment
-
aight well i have a preset tank and i changed up the trigger a bit now all i need is air but so far i got it to stop just a lil longer pull than i wanted. thx for the info though."Life Is A Garden Dig It" Joe Dirt
Black powerfeed Emag 1.37 w/ warp and ev2 :headbang:
lookin for emag ups u got em i want em :shooting:
98% of american teenagers have tried pot. if you are part of the 2% that hasnt, put this in your signature. :wow:
My emag shootin with crap paint and old ev2Comment
-
best bet is to get a certified tech to checkout your electronics and possibly flash the board to 3.2, and yes its normal for the RT valve to warmup sometimes under fast strings of firing.
Comment
-
I also have a emag
its also 1.37
and best of all I have bounce also , Its from good tuning , I was playing with my trigger pulls and a Can get like 3-8 shot burst , its bounce very nicley
Comment
-
Bounce in E-Mode is usually a result of the trigger rod being too long and coming into contact with the trigger when you pull it in E-Mode. If this is the case, pull out the sear assembly and with some pliers turn in the trigger rod just a hair and reassemble.
The "electronic" bounce is found usually only on 3.2 software, because of the way the software reads the trigger pull in comparison to 1.37. This can be fixed by reversing the polarity of the solenoid.
I do the AGD 3.2 upgrade, if anyone is interested.Comment
Comment