x-valve at 800 psi set up

[player4]

I have tried too many times to create a set up for my mag that works.
I have an x-valve running at 800 psi.
I was wondering if anyone else has this set up, and if so what spring, carrier, and amount of shims do you have to make it work. Thank you.


I also have a really dumb question. I do not know what each carriers' markings mean. Can someone please tell what the order of the carriers is. If anyone could give me a good enough explaination that would be awesome.

[CaliMagFan]

try the link in my sig if none of this helps... but the guide to teh carrier #'s is thus.... a ring/line cut around the carrier means a whole number (1,2,3,4) and the dot on the carrier denotes a half number, so 2 lines and a dot would be 2.5 carrier...


my setup is something like #2 carrier, 3 lvl 10 shims, ult with 5 shims, middle (red) bolt spring.... and an 800-850 output fixed HPA tank...

good luck

-kyro

[Titansu]

O-ring inside carrier
Pickup one of the brass O-ring carriers (4) and push a power tube O-ring (2) into the end that does not have a tapered hole. It should not go in one side and either slide in or press into the correct side. There are 5 carriers supplied with your kit, each one is a little bigger than the next. They each have small grooves on the outside to help you tell them apart. The more grooves the larger the carrier.

http://www.automags.org/resource/level10/index.shtml

[player4]

Thank you CaliMagFan..........that helped a whole lot