body problem

[paintballrulzs]

when i remove the back screw my valve comes out a little and won't go any further. I have to hit it hard to get it out or remove the body from the body rail to get it out.

[Ariestsheft]

before removing your valve pull the trigger with the gun degassed, this will disengage(sp?) the on/off and should fix your problem.

[paintballrulzs]

ok thanks i will try that. Do i hold it down too? i have a benchy by the way

[DYE-BaLLeR]

u can hold it but u dont have to

[PyRo]

What is probably happening is there is enough pressure in your valve to keep the on-off pin down, but not enough to fire the gun. When the pin is down, it will get cought on the rail, and prevent the valve from moving back past that point.
Just hold down the trigger as you pull it out, and it should slide right out.

[DYE-BaLLeR]

if you have a non screw in tank turn the on off valve off, fire the gun as many times as u can, then pull a quick disconect to release the air. then there will be no pressure, if u have a screw in, just take the tank out

[paintballrulzs]

I haven't played in 2 months and have disassembled my gun a few times since. Well i got a new bolt for xmas and wanted to put it in and had this problem. If i hold down trigger then it comes out with no problems