Here the the situation, I have an emag, it is an old one SN#em00146 no stars or anything and a .68 classic. well, my screw that holds my e-mag valve in brole off inside the valve while I was shooting at a local field, so naturally I switched the classic valve for the e-valve to still use my e-mag, but when I got my valve home I realized that while the classic valve fit in both guns, my classic mags body will not let the e-mag valve fit. this doesn't make any sense I thought anything except the old RT valve would fit anything else. the body for my classic is a centre feed nonclamping, uses old style barrels. is it alright to just dremel the barrel to get the 1-2mm of extra clearence I need?
-
E-mag PF HL chrome
smart parts teardrop barrel
.68 classic centre feed
intelleframe
omega rail
light,tight gas thru grip and vert adaptor
J&J barrel -
is your classic body powdercoated or warped in any way. I've seen this happedn with bodies that have been powdercoated or messed with cause then they warp or have a different size for the valve to go in. -
Both valves should have the same dimensions. Check for something sticking out that may prevent the valve from going in the body.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
Comment