Magnet not being recognized!

[halo13]

I was trying to shorten the trigger pull buy moving the magnet in the trigger towards the elecronics. For some reason, the gun would not electrically start. After tinkering with the screw right under the "E", by the mode selector, the LED started to work again. Unfortunately, the Magnetic Sensor System (MSS) does not seem to recognize the presenceof a magnet. When the trigger is pulled, the MSS does not snap into action like it used to. Also, the Shot counter does not record the number of shots, and the burst, and auto modes do not work. In short, whatever the trigger would normally activate, does not activate. I am assuming that it is because of something to do with the magnets. So, how do i fix this problem?

[Potatoboy]

yeesh, try a seach, this has happened a buch, your magnet is too close to the sensor, screw it in some.

if this isn't the problem, i don't know what is

[Butterfingers]

the magnet is probably too far in, back it out until the gun fires.

There is a small window in which the hall effect sensor can sense trigger movement.

[halo13]

I afraid that i'm using stripping the trigger magnet by using a bracket tool (i don't know the exact term) that is to small. What is the correct size that i should be using?

[BlackVCG]

1/16" allen key.

[headcase]

BlackVCG

Are you a displaced New Englander too?

[BlackVCG]

No, just a New England fan.

[AutoMaggot]

New England kicks ***... BTW, is it possible to make a "hair" Emag trigger (as in incredibly short... like vapor bushmaster short)?

[BlackVCG]

.3mm short enough for you?

[AutoMaggot]

yes