May get a boo yaah

[Xugg'420]

Anyone know where you can get Hyper and Boo-yah grips for cheep?

[unseenunheard]

well Bearshirt covered a good area of it but i also have a boo-yahh on my mag and it worked right from the start but one problem i had later was that i had to change the pt spacer as i had a longer one in before i got the boo-yahh and it began to leak and also i had to change my ANS bolt out and replace with my stock. the main thing is to not get frustrated and think about the problem because an electro frame brings out the weak points of your gun but once you get it working it rips.
i might would recomend that you have a parts kit on hand in case any orings need changing GOOD LUCK!

------------------
-Paul-
[email protected]

[Drizit]

thanks all, as soon as i have the coin i think i'll give it a try.

------------------
MicroMag Phase 1
S/N GFX001489
Custom ring trigger
MaxFlow 68/3000

There must have been a time
when we could have said no.

[unseenunheard]

1st yes Boo-yahh went out of busines but they were only the distributer, a machine shop (i don't know where they are located but anyways) that was building the frames for boo-yahh got into a disagreement with boo-yahh and stopped selling the frames to them. however they are still in production and fully warranteed.
2nd the warranty is at the moment through PMI who are at the moment are helping with the technical calls and warranty until the machine shop that builds the frame can set up their own tech line. but all you have to do is call PMI @ 1-800-334-0502 and they can explain the hole deal to you better than i can.


------------------
-Paul-
[email protected]

[BayouMagMan]

Drizit,
I recently got a Boo-Yaah, and while I had no problems as far as installation goes, so far I have eaten one ANS bolt and a sear(with in like 2 cases of paint). I am happy with the Boo-Yaah over all but need to work on it more to find what is causing these problems.