warp feed/ball chops

[darthp]

I have a rt with the ule warp body on it and a logic vert frame and I think my warp is causing ball chops. I have changed springs to the longest spring and I still chopped two balls yesterday. Its really bad with the other two springs. So I changed to my micromag without the warp feed and with the shortest spring and still using the same paint and didn't chop at all. When I put in a fresh battery in the warp feed it does better but still chops every once in a while. Is there something wrong with my lx setup or should I try the 12 volt mod for it? What I really want to know is can a warp feed cause ball chops?

[trains are bad]

There's something wrong with you warp setup. Maybe the tube in pinched, the dwell is wrong, your intellifeed is glitching. If you aren't using intellifeed that's probobly your problem right there. You don't need the 12v mod on a mech mag, I have never been able to outrun a 9v warp with one. I do use the bigcell mod though.

[MonsterMag]

If your Level 10 is tuned properly then you shouldnt chop , it sounds like there is a problem with the warp set up, like the guy before me said.

[B.A.M.]

If your Level 10 is tuned properly then you should chop , it sounds like there is a problem with the warp set up, like the guy before me said.

[Muzikman]

Are you sure it's actually chopping? Why I ask is it might be double feeding. Is the ULE body a vert or warp feed? Is the ball detent intact? Is it screwed in to far?