does anybody know....

[Little_Ho]

Hi there,
does anybody know the exact cut out messurment for the Pumpmag kit for the Rail???
I would like to it myself. But i need the messurments to make sure it is working corect.
That means the length, width and and the deep.

Can someone help me????
Because i have it but i did not find a Rail with the cut out. And so far i can say they are hard to find....

Little_Ho

[frop]

pm one of the dealers that does the milling, they'll help you out. too bad i don't remember who does it...

[GA Devil]

if im not mistaken BlackVCG does it. Might want to check with him and see.

[craltal]

I have copies of the machinist drawings. pm me with your email address if you want copies.

[Little_Ho]

Hi craltal

send you a pm....

Little_Ho

[Muzikman]

Remember, at the end of the groove, it has to rise up. I am not sure what you are going to cut it with, but keep that in mind.

[Little_Ho]

Hi Guys,
ill keep that in mind Muzikman, but because i like it here ill send the rail off to BradAGD.
He offerd me the Service to do it.
So i got what i need....

Thanks
Little_Ho