ok im going to kill a few questions in one thread so first and most importantly i had massive problems with my reloader b shutting down on me on sunday i would play and then the hopper would shut off and i would have to disconnect the battery and then reconnect it before it would turn on again. is this cuz there is no z-code or is it a deeper problem. the batteries were brand new as in i replaced them that morning with 6 energizers the problem first happened in speed mode 3. i then turned it down to speed mode 2 with longer lasting results but ofcoarse had some feed issues with speed one the paint was crap to say the least. thank god for ripdrive or i would have been sitting out almost every game i played!
secondly i just picked up the x-power kit and i am just checking to make sure that the voltage put to the warp side of the x-power is enough to fully power the reloader or if it is too much for the board to handle.
thanks for any help
enemy!!!
secondly i just picked up the x-power kit and i am just checking to make sure that the voltage put to the warp side of the x-power is enough to fully power the reloader or if it is too much for the board to handle.
thanks for any help
enemy!!!
Comment