Hardline?

[warbeak2099]

I was checking out Palmer's air fittings section (they have the coolest stuff there) and I came across some hardline. I thought to myself, "Now that might be neato." How well would this work? It's copper, stainless, or brass hardline rated pretty high (the brass is 3000psi and the stainless is 3900psi). Would it work well feeding an x-valve? How about if I crank the input pressure up to around 1000psi for bouncing? Does it have a high enough flow rate or will it starve the marker? Thanks.

[stoupa]

if you want to run hardline to your valve, you should read Doc's post

http://www.automags.org/forums/showthread.php?p=1249920&highlight=hardline#post1249920

[warbeak2099]

Ah, thank you. I've decided I'll just go back to ss braided hose with a qd. Can't use macroline if I want to get bounce (1000psi doesn't exactly play nice with macroline).