micro emag

[nevets11_2003]

i just got micro emag with no instructions it has 3.2 software and i were wondering what the modes door mean.....
there ts and i no that mean total shots.
*sps ??? 8-20
*ace ??? 0-2
*shbf ??? 4-100
*trg ??? off

if someone could tell me what these mean and do.... or find an internet manual or both
thanks steven

[personman]

Well,
SPS = shots per second (rate of fire)
ace (anti chop eye, you cant use it on the micro emag so keep it on 0)
shot buffering.. not sure how to use this one
and i dont know what trg is.
Sorry.
:)
Enjoy your micro emag

[Dayspring]

SHBF= Shot buffering. It's the time that the gun will wait after the gun fires before it starts looking for another trigger pull. The # equals the time in ms. The lower the #, the faster you can go.

Trg on/off= the trigger test mode. It's there to show where the gun will register the magnet so you can tune your trigger.

SPS= ROF cap. Self explainatory.

ACE= Anti Chop Eye. Leave this on 0 otherwise the gun won't fire.

[nevets11_2003]

thanks

trg the trg wont go on/off on my gun its just off...
and i have 3.2 software so does the shots per second do ne thing..? i have eletric mode, mech and, hybrid...
thanks steven

[Dayspring]

Are you pulling the trigger? Is the safety on?

The SPS will limit the ROF. So if you set it at 10 and you pull faster than 10, you'll only shoot 10.

[nevets11_2003]

ok thanks

yes it works now just had to pull the triggir

[Titansu]

yes it works now just had to pull the triggir

You should wait to get AGD v4.2... It will automatically point your gun to the nearest enemy and shoot them for you.

Dayspring, you got that on your Xmag, right?