Hey whats up!? I just felt like switching out my ULT kit to my stock on/off assembly, here is what i did. I took the ULT assembly out and then dropped in the oring that goes to the very bottom of the on/off hole followed by the stock on/off assembly. I noticed that the stock/off looked a little funny because the pin seemed longer than usual. Well i found a small teflon oring in the bag that the stock on/off was in and i placed it on top of the pin. I placed the assembly into valve and oiled everything up and put it back together. I gassed up the gun and when i pull the trigger ( ITS LIKE A BRICK! a very VERY heavy trigger pull)the first shot goes off but the seconds does nothing. The sear pin is pushing back on the trigger but the gun just wont do anything. Wait about 2 seconds and it works again but the next shot does nothing. Every other shot works. Well i pull the valve out and the stock on/off assembly and noticed that the little teflon oring that i placed on the on/off assembly has forced itself into the center of the oring that lays on the bottom of the valve. Is this normal? what could be the problem? I have the red spring and the 2.5 carrier with NO shims in my lvl X. I had about 1050psi going into the gun with the velocity dialed in.
-
-
both o-rings go in the bottom the alrger one on the outside then the smaller one that seals the on/off on the inside.
sicne you havent used the on/off in a while it may just need oil as well.
-
also remember the ULE dropped the trigger 2 lbs. so its going to be a hard trigger pull. but yes both o rings go in the bottom. if you want to have some fun and have a reactor on off. remover the bottom small o ring and watch you gun go full auto.Comment
Comment