Level 10 and ULT

[codeman35]

I was adjusting my lvl 10 and ULT and while I was shooting it with my finger in the breach(because it's midnight and my parents will get ticked if I wasn't), the sear started to reset really slow. My tank is right around 1000psi. Could it be doing this because the tank is a little low. It's an x valve. It was working fine for around ten shots and then it started acting up. Thanks.

Cody

[Skywalker]

Yeah your tank is pretty low, but it's prolly not reseting completely b/c your finger is in there. Fire a few shots into your pillow and see what happens.

[yakitori]

Its probably cause your tank is low on air. Mine starts doing that sometimes around 1000psi and a little under. also, since your ULT is fairly new and needs breaking in, it works better w/ a drop of oil on the ULT. I take my valve out and remove the on/off, and take the ULT halves apart and put a drop of oil on the ULT on/off pin, and a drop on the white o ring on the bottom half of the on/off.

[codeman35]

Ok, I changed around some carriers, some shims, and got my tank filled. I shot it a few times and now it's working like a charm, no shoot down or short stroking when pulling the trigger fast. I'm just going to leave it alone now. Thanks for the help.

[Tunaman]

Yes. LEAVE IT ALONE NOW!

[codeman35]

Thanks for that really technical advice Tuna.