could someone help me

[Carbon Blue]

Thats to high of pressure input. You can adjust your sear too.

It says DIRECTLY on the gun rail Recommended input- 600-800 psi

I get bounce when my sear pin is a bit to much off my trigger, and then when i pull the trigger lightly.

im telling you that you should never adjust your sear rod length as it is to AGD specs, its been said time and time again and 850psi-900psi is not even alot of input pressure. With the stock sear rod length you will start to experience bounce at around 850psi-900, but then again all valves are different as i have seen major bounce from an xvalved mag with a preset crossfire. Many people run north of 900psi into their xvalves and i have even run 1200psi. I dont experience bounce till about 850-875psi.

[SpitFire1299]

im telling you that you should never adjust your sear rod length as it is to AGD specs, its been said time and time again and 850psi-900psi is not even alot of input pressure. With the stock sear rod length you will start to experience bounce at around 850psi-900, but then again all valves are different as i have seen major bounce from an xvalved mag with a preset crossfire. Many people run north of 900psi into their xvalves and i have even run 1200psi. I dont experience bounce till about 850-875psi.

I wasnt fighting with you, im just saying that it says Recommended psi input on the rail. I got a new vertical frame and i had to adjust my sear length, and i also had to play with it. I noticed that at certian areas it would bounce more and bounce less.. or not at all.

Dont want to fight.