i just got my lvl ten bolt and it has a leak that i can't understand how to fix. The set up is everything needed and ONE shim. It's a constand leak when i gas it up though and when i put my squeegie down to try n push the bolt back it keeps leaking. HELP ME PLEASEEEEEEE
-
-
make sure the o-ring in the spacer is tight enough, and then add shims until the leaking stops.
emag block body-chrome rail-stock frame-
classic valve-32 carbon fiber 12"-
chrome palmer stab
My Feedback -
if adding a shim does not work try going up half a carrier size then put a couple of shims in before trying the next half size up carrier. Tuning takes patients but the pay off is great not having to send your valve out.ROBB2269 :shooting:
Minimag rail, X-Valve black, ULE CF body black, ULT trigger, ULE Intelliframe, Shochtech mini drop w/on off, Dye Ultra light barrel kit, Evo II z-board smoke.
:cheers:
Titenium Karnivor, Dye Ultra kit, Evo II z-board
Comment
-
Your carrier size is wrong. Try other carriers... :)Comment
-
Start with no shims at all.
Test fit your carrier and o-ring on the bolt stem until you find one that just fits on the bolt stem. It should provide some resistence but not be stiff. It should slide easily. Use that carrier and o-ring in your setup. This will provide a good start for fine tuning.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
Take out the carrier and follow the size chart that came with the lvl 10 kit, sounds like your carrier is to big your gonna want to go down one size and you can remove the shimms as well as almost always there not needed. I would also recomend the red spring.
Comment
Comment