Anyone know who did the milling on this RAIL?

[dahvaio]

I just received a ULE Rail that I purchased from AdaBita... and it was milled by someone and I was wondering if anyone knew the persons work.... Wanted to say great job on the milling...

I've included a picture of my Original RT-ULE rail and the one I purchased from AdaBita...

[JadedT]

Looks like RogueFactor's work. Check out the dealers' forum.

[Blennidae]

Might also be BlackVCG's work. He did some simillar work on a stock Emag rail I had.

[RRfireblade]

Not me is all I can say. I don't go thru the bottom like that in the center section. Don't think Black does either.Not sure about the others.

[Blennidae]

BlackVCG did go thru the bottom of the center section on my Emag rail.

[RRfireblade]

oh, ok...then there you go :) Maybe.

[Sk8ermog]

I know it's not Lukes cause he hasn't done one like that, but if you want to get a body cut like that or looking even nicer then check out Lukes work on my rails:






Check out my sig for more info.