I'm not new to cockers but I just got a new one and I need to reset the LPR and Reg. Is there anyway I can do at least one of them? Or do I need special tools and such?
Thanks
Mike
Thanks
Mike
-
-
wrong place dont yo think? try worrgames forum or pbnaton
ROBB2269 :shooting:
Minimag rail, X-Valve black, ULE CF body black, ULT trigger, ULE Intelliframe, Shochtech mini drop w/on off, Dye Ultra light barrel kit, Evo II z-board smoke.
:cheers:
Titenium Karnivor, Dye Ultra kit, Evo II z-board
-
If by reset you mean sweetspot, you'll need a set of hex keys to alter the pressure on most regs. Shouldn't need anything else that I can think of, other than paint and a chronograph.
Proper regulator sweetspotting procedure can be found here:
Sweetspotting your LPR is dead simple. Sweetspot your primary regulator and then don't touch it.
If you want to minimize force on the paint:
Turn the LPR down until it no longer cycles properly, then give it a quarter or half turn up.
If you want to maximize bolt speed:
Turn your LPR up until something leaks or you blow a hose off. If you have an eblade, turn the LPR up until it starts venting itself to release pressure. Turn it back down a quarter or half turn.
Making the action soft on paint will require a really smooth ram, and a lightweight pump arm, back block, and bolt. The bolt should be well-fitting and not have any major drag either.
Maximizing bolt speed will cause extra wear and tear on your marker's parts in most cases, but it's not something to worry about.Comment
Comment