I have a 3.2 emag and when ever I try and shoot it ends up going FA tried using both lvl 10 and lvl 7 bolts makes no difference. Everything is oiled up nicely and the battery is fully charged.
Any ideas?
Any ideas?
-
-
hmm
is the screw on the trigger to close to the hall sensor try and back it out like a 1/4 a turn .. -
The on off is not sealing. It was mechanical FA not sure if I fixed it now though because I ran out of gas... Think I need to buy a new xring.Comment
-
Update switched the xring with brand new oring the is absolutely NO sealing happening what so ever I beleive the sear is not pushing the pin is up far enough how can I adjust this?Comment
-
check and make sure the pin isnt broken. my gun broke the pin in my xvalve for some random reason the other day and it would go f/a as soon as i put air to it.
chrisComment
-
Pins in perfect condition im prettry sure just the throw of the sear is off. Thanks for the reply tho could happen...Comment
-
on/off
is the on/off the stock emag one .. if you changed out the valve .. to say from emag to x valve .. the emag on/off has to be in the valve or did you buy used lowers and toss what ever valve you have on the lowers..Comment
-
I did not just assemble this gun I have been using it for along time.... Its a stock ss emag valve. Do you adjust the throw of the sear where it screws into the solenoid?Comment
-
Its not the sear... the on off will not seal from some bizzare reason.Comment
-
Fixed, thanks tmaxx.Comment
Comment